Here's part two of my partsocaster build. See part one here. https://steemit.com/music/@sketch.and.jam/building-my-own-guitar-part-1-uzh47t4b

Now its time for wiring the pickups to the main 5-way switch. I got a toneshaper solderless kit that allows for a more clear signal to go to the amp without worrying about messy solder. Simple strip the ends of the wires on the pickups and plug them into the green part on the left side. The letters N, M and B stand for neck, middle and bridge pickup. GD stands for ground. The green connectors on the right go to the input jack. The little white switches in the middle can be configured to rewire your pickups in series, parallel, vintage or modern wiring depending on what combo of switches you turn on and off. The big white plugs go to the knobs.

Here is the old wiring, i just snipped off the wires to the old controls and plugged them into the new controls. I had to do a bit of research to figure out what color wire does what. Red and orange wires bring the signal to the controls, the green is the ground wire.

Now everything is wired to the new controls. You just have to turn a tiny little screw to clamp down the pickup wire into the controls.

Next I finished attaching the tuners to the neck. These tuners also had to have little joles drilled in back to adhere them in place. I used my trusty dremmel to predrill the holes and then used a tiny screwdriver to put each screw in by hand.

Next the neck and body need to be predrilled. I lined them up first then used my dremmel and an appropriate sized bit to predrill the holes in alignment with the neck.

I made little marks in the back of the neck first before drilling to the right depth. You really need to keep the drill straight and put the dremmel on a low speed and slowly proceed. A messup here could ruin the neck forever :-(

Fortunately the neck went on perfectly and fit perfectly so there was no need for tricky carving or shimming. Now its time to intonate the bridge. Unfortunately I skipped a few picture steps like attaching the bridge and springs as I was getting excited at the guitar being close to playable.

I setup the bridge to rest on the body for better tuning stability. Someday after I put on the wooden pickguard I might set the bridge to float but that tends to cause tuning stability problems on these 6 screw bridges.

Here it is all finished up. All the puckups work and the action and intonation is good. I even did a few divebombs on the tremelo and it stayed in tune.

I'll live with this setup for a while before swapping the white pickguard out with a wooden pickguard. I may give the body some more sanding and a truoil finish next.
Here's a sound sample right after I finished puttong it together. https://youtu.be/0_MDdHptvmM

Posted using Partiko Android