⚙️🔩🔧How to change valve rubbers without having the right extractor[ESP/ENG],

Good night, welcome everyone to my blog👋. I hope you are in very good health, today I want Show me this work

Como cambiar gomas de válvula a este motor 2f Toyota sin sacar la cámara con tan solo sacar tapa válvula desmontar bujías y sacar flauta

How to change valve rubbers to this 2f Toyota engine without removing the camera just by removing the valve cover, removing spark plugs and removing flute

Procedemos a sacar las 6 bujías sacamos la flauta y empezamos a cambiar las 12 gomas de válvula que necesitamos cambiar ya que el cilindro número tres y número seis está mojando la bujía de aceite nos ponemos a cambiar las gomas de válvula

We proceed to remove the 6 spark plugs, we remove the flute and we begin to change the 12 valve rubbers that we need to change since cylinder number three and number six are wetting the spark plug with oil, we begin to change the valve rubbers

Como pueden ver no tengo extractor con tan solo dos llaves 9/16 y dos pedacitos de ángulos con dos agujeros en la punta para usar los espárragos que vemos en la foto para hacer el prensa resorte y proceder a cambiar las gomas

As you can see I don't have an extractor with only two 9/16 keys and two bits of angles with two holes in the tip to use the studs that we see in the photo to make the spring press and proceed to change the rubber bands.

Ya he cambiado 3 gomas de válvula como ya estoy al frente del carburador que con los ángulos no puede resolver porque son un poco largos para no pícaros uso las dos llaves 9/16 y hago lo mismo, hundo el resorte por el agujero de la bujía número dos meto un pedacito de cabilla semi doblada con el pistón arriba para evitar que la válvula se vaya hasta abajo y tenga que desmontar la cámara

I have already changed 3 valve rubbers as I am already in front of the carburetor that cannot be solved with the angles because they are a bit long so as not to be rogues I use the two 9/16 keys and do the same, I insert the spring through the spark plug hole number two I insert a bit of semi-bent rod with the piston on top to prevent the valve from going all the way down and having to disassemble the chamber

Como vemos ya monte las 24 gomas correspondientes procedo a montar la flauta pongo todo en su lugar monto su tapa válvula para luego limpiar bujías y montarlas

As we can see, I already assembled the 24 corresponding rubber bands, I proceed to assemble the flute, I put everything in its place, I assemble its valve cover and then clean the spark plugs and assemble them.

Ya con sus 6 bujías limpias procedo a montarlas y colocale sus cables que la enumeración de encendido es 153624 listo para encender ya que las fallas eran las gomas de válvula porque estaban bastante deterioradas

With its 6 spark plugs clean, I proceed to assemble them and place their cables, the ignition number is 153624, ready to ignite, since the faults were the valve rubbers because they were quite deteriorated.