[ESP-ENG] Confetti Cannon with Toilet Paper Rolls and Plastic Plates | Cañón de Confeti con Rollo de Papel Higiénico y Platos Plásticos
Hello hive friends, for me it is a pleasure to be here with you all again, sharing a creation I made, it turns out that I was at home, and well I ran out of toilet paper, I said, I will do something with the roll, to recycle it and make something fantastic and unique. Well I elaborated friends, a confetti cannon, super easy to make, I used some plastic plates I had to make the wheels, let's start.
-Materiales:
-1 Rollo de papel higiénico.
-2 Platos de plástico.
-Silicón en barra.
-Yesquero.
-Pincel.
-Foami.
-Tijera.
-Pintura al frío negra.
-Paso 1: Primeramente vamos a pintar de negro, todo el rollo de papel higiénico, solo por fuera, no malgastaremos pintura por dentro ya que no será necesario. Dejamos secar muy bien nuestro rollo de papel higiénico. Como los platos eran muy grandes para las ruedas, y no tenía otros pequeños, decidí cortarlos a un tamaño accesible para que sirviera.
-Materials:
-1 Toilet paper roll.
-2 Plastic plates.
-Silicone stick.
-Yesquero.
-Brush.
-Foami.
-Scissors.
-Black cold paint.
-Step 1: First we are going to paint black, the whole toilet paper roll, only on the outside, we will not waste paint inside as it will not be necessary. We let our toilet paper roll dry very well. As the plates were too big for the wheels, and I didn't have any other small ones, I decided to cut them to an accessible size to fit.
-Paso 2: Procedemos a pegar con silicón las ruedas de nuestro cañón, una por un lado, y la otra por el otro, luego vamos a recortar en foami, dos círculos, uno grande y otro más pequeño, uno va primero y luego el otro dentro es una especie de adorno en la rueda. luego lo pegamos cuidadosamente. Procedemos a cortar una parte de papel crepe, una tira gruesa, la cual pegaremos al inicio del cañón, en la punta por decirlo así.
-Step 2: We proceed to glue with silicone the wheels of our cannon, one on one side, and the other on the other, then we will cut in foami, two circles, one large and one smaller, one goes first and then the other inside is a kind of ornament on the wheel. then we glue it carefully. We proceed to cut a part of crepe paper, a thick strip, which we will glue at the beginning of the barrel, at the tip so to speak.
-Paso 3: Cortamos unas tiras finitas de papel crepe, super finitas, ya que este será la simulación del confeti que irá dentro de nuestro lindo y sencillo cañón, super fácil y divertido, espero que les guste amigos.
-Step 3: We cut some thin strips of crepe paper, super thin, as this will be the simulation of the confetti that will go inside our nice and simple cannon, super easy and fun, I hope you like it friends.
This is my final result, I hope you like it very much, blessings to all.
All photos are of my authorship and edited with canva.